Took delivery on the DBS Mods antenna(s) yesterday. One for P3 and one for Solo. The P3 comes with a REALLY nice stainless bracket and clips on to the bar of the Phantom 3.
Since there is no bracket available for the Solo I was going to start from scratch and build one out of aluminum with material anyone could buy at Home Depot. However, it turned out with some cutting and filing the stock P3 bracket worked great.
I am going to paint the panel black today and while that is drying I will probably do some finish filing on the bracket.
This took about 15 minutes to fabricate but I have a large shop full of tools. Its basically just cutting, filing and drilling a couple holes.
First of all here is the stock P3 bracket. As I said its a nice piece !
View attachment 486
This is the bracket held up to the Solo controller where the mount clips on. I cut off the sides (yellow), cut out the area with the white dotted line and drilled two holes shown in black. I used screws with nylock nuts and the solo mount captured the nuts perfectly so they would not spin as tightened.
View attachment 487
Here is a picture of the cut down mount installed.
View attachment 483
Here is the picture with no device mounted
View attachment 484
And here is the final picture with the Samsung Tab 3 (8.4").
View attachment 482
The way the Solo tablet mount is decided there are a million ways to easily mount the DBS panel with just a bent piece of aluminum strap. The panel has two studs on the back with wingnuts so its easy to attach.